DJI FlyCart 100

Aircraft

Weight (without payload)
55,2 kg (with lifting system)
60,2 kg (with winch system)

Excluding the weight of the battery, dual battery compartment and accessories, cable and hook.

Maximum takeoff weight
170 kg

The maximum takeoff weight of 170 kg is the drone's performance specification. Please observe local laws and regulations during actual use. In the following countries and regions, the maximum takeoff weight is limited to 150 kg: Brazil, Japan, Australia, Türkiye, Saudi Arabia.

Maximum diagonal wheelbase (motor to motor)
2330 mm

Diagonal length (tip to tip)
3904 mm

Dimensions (arms and propellers unfolded)
3220 mm × 3224 mm × 975 mm

Overall dimensions (arms folded, propellers unfolded)
1820 mm × 1840 mm × 975 mm

Overall dimensions (arms and propellers unfolded)
1105 mm × 1265 mm × 975 mm

Folding method
Towards the body

Battery configuration
Supports dual-battery and single-battery configurations

Single-battery mode is intended for emergencies.

Maximum flight distance
At a takeoff weight below 149,9 kg: two batteries 12 km, one battery 6 km

These data were obtained using a DJI FC100 with a fully charged new battery at a takeoff weight of 149,9 kg, flying at a constant optimal speed until the battery level reached 0% in a windless environment at 25 °C at sea level. Results may vary depending on the environment, actual use and firmware version. Always follow the instructions in the app during operation.

Maximum hovering time
At a takeoff weight below 149,9 kg: two batteries 12 minutes, one battery 6 minutes

These data were obtained using a DJI FC100 with a fully charged new battery at a takeoff weight of 149,9 kg, hovering in a windless environment at 25 °C at sea level until the battery level reached 0%. Results may vary depending on the environment, actual use and firmware version. Always follow the instructions in the app during operation.

Maximum flight time
At a takeoff weight below 149,9 kg: two batteries 14 minutes, one battery 7 minutes.

These data were obtained using a DJI FC100 with a fully charged new battery at a takeoff weight of 149,9 kg, flying at a constant optimal speed until the battery level reached 0% in a windless environment at 25 °C at sea level. Results may vary depending on the environment, actual use and firmware version. Always follow the instructions in the app during operation.

Operating temperature
-20 °C to 40 °C

Measured at an estimated solar irradiance of 960 W/m². Long-term exposure to high temperatures may shorten the service life of certain components.

Ingress protection rating
IP55

The protection rating is not permanent and may decrease due to ageing and wear caused by long-term use. The protection rating does not apply to the propulsion system. After flying in the rain, it is recommended to run the aircraft at idle on the ground for 1 minute to prevent corrosion or rust on the propulsion system (precipitation of more than 24,9 mm within 24 hours).

Hovering accuracy (with a strong GNSS signal)
RTK positioning enabled:
± 10 cm (horizontal), ± 10 cm (vertical)
RTK positioning disabled:
± 60 cm (horizontal), ± 30 cm (vertical)

RTK/GNSS operating frequency
GPS + Galileo + BeiDou + GLONASS

Maximum ascent speed
5 m/s

Measured in dual-battery mode at sea level at 25 °C under windless test conditions.

Maximum descent speed
5 m/s

Measured in dual-battery mode at sea level at 25 °C under windless test conditions.

Maximum horizontal speed
20 m/s

Measured in dual-battery mode at sea level at 25 °C under windless test conditions.

Maximum flight altitude (above sea level)
6.000 m

The drone's payload capacity decreases as the takeoff altitude increases. 6.000 m above sea level is the maximum safe altitude for the drone with two batteries and no payload (takeoff at 4.500 m above sea level).

Maximum flight altitude (relative to takeoff point)
1.500 m

Flight altitude is limited by the takeoff altitude. The maximum flight altitude for DJI FC100 is 6.000 m.

Maximum wind speed
12 m/s

The maximum wind speed during takeoff and landing is 12 m/s.

Propulsion system

Stator size
155 × 16 mm

Motor KV value
60 rpm/V

Propeller material
Carbon-fibre composite

Propeller dimensions
62 inches (1574,8 mm)

Propeller type
Two-blade folding propeller

Number of rotors
8 pairs

Safety system

Safety system type
Front millimetre-wave radar
Rear radar (single board)
Downward radar (single board)
LiDAR
Quad-Vision system
FPV

Millimetre-wave radar EIRP
<20 dBm (NCC/MIC/KC/CE/FCC)

Operating temperature
-20 °C to 40 °C (-4 °F to 104 °F)

Operating environment requirements
Sufficient lighting and recognisable surroundings

Operating power consumption
LiDAR: 6,5 W
Front radar: 18 W
Downward radar: 5 W
Rear radar: 5 W

Field of view (FOV)
LiDAR: vertical 272°, horizontal 60
Front radar: horizontal 360°, vertical ±45
Downward radar: left/right ±12,5°, front and rear ±22,5
Rear radar: left and right ±45°, front/rear ±45
Quad-Vision system: horizontal 360°, vertical 180
FPV camera: horizontal ±86°, vertical 108

Measurement range
≤ 60 m

The effective detection range and the ability to avoid and navigate around obstacles vary depending on ambient light, rain, fog, as well as the material, position, shape and other characteristics of the obstacles. Downward detection is used to assist with terrain following and altitude stabilisation, while detection in other directions helps with obstacle avoidance. AR safety assistance functions are for supplementary guidance only. The operator must check the safety of the surroundings during operation.
Note 1: Downward detection supports terrain-following flight. If the underside collides with obstacles, the user is responsible.
Note 2: Due to limitations in the performance of the safety system, the aircraft cannot automatically navigate around moving objects, and the user is responsible for accidents of this kind.
Note 3: Obstacle avoidance for cargo is intended only as flight assistance; if the cargo or lifting cabin collides with an obstacle, the customer is responsible.

DJI O4 video transmission

Maximum transmission range
20 km (FCC)
10 km (CE)
12 km (SRRC)
10 km (MIC)

Measured in an unobstructed, interference-free environment. The data above show the maximum communication range for one-way flights without return flight under the respective standards. Please follow the instructions in the DJI Delivery App during flight.

Operating frequency
2,400 GHz to 2,4835 GHz
5,725 GHz to 5,850 GHz

The supported operating frequency bands and corresponding available ranges vary by country/region. For details, please refer to local laws and regulations.

Transmission power (EIRP)
2,4 GHz: <33 dBm (FCC), <20 dBm (CE/SRRC/MIC)
5,8 GHz: <33 dBm (FCC), <30 dBm (SRRC), <14 dBm (CE)

Live view quality
1080p/30 fps

Antenna
4 antennas, 2T4R

4G-enhanced transmission
Supported

Lighting

Lighting direction
Forward, downward

Control mode
Automatic, manual

Maximum lighting power
46 W (standard)

Parachute

Model
E2MSF-100A

Landing speed
≤ 7 m/s

These data were measured at sea level at 25 °C, under windless conditions, with the aircraft at maximum takeoff weight and the parachute opening at an altitude of 100 m.

Parachute shape
Square

Material
Nylon

Minimum opening altitude
100 m

When opened at this altitude or above, it ensures that the aircraft reaches a stable speed upon contact with the ground.

Operating temperature
-20 °C to 40 °C (-4 °F to 104 °F)

Ingress protection rating
IP55

Battery life with the mainboard switched off
≥ 1 hour

Storage card capacity
Independent storage, real-time recording of every flight, can record 10 flights.

Alarm method
Buzzer alarm and light alarm

Opening method
Manual opening, automatic opening

Winch system

Model
A2EWH-100A

Dimensions
960 mm × 805 mm × 669 mm

Hook charging method
Wireless charging, Type-C charging

For wireless charging, the hook must be fully tightened.

Hook power supply
10 hours

Measured in an ideal windless environment at sea level at 25 °C. Results may vary to different degrees depending on external environmental conditions, usage patterns and firmware versions. Please follow the app instructions during actual use.

Cable length
0–30 metres

Maximum retraction speed
1,2 m/s

Weighing function
Supported

Hook opening and closing function
Supports active control via app or button

Emergency escape mode
Cable-drop escape

Automatic balance control
Supported

Manual wheel control for retraction
Supported

One-tap release and retraction
Supported

Intelligent delay protection
Supported

Lifting system

Model
A2EDL-100A

Dimensions
960 mm × 805 mm × 669 mm

Cable length
10 metres

Emergency escape mode
Escape by cutting the cable

Automatic balance control
Supported

Weighing function
Supported

Recommended cable length
10–15 metres

DJI DB2160 Intelligent Flight Battery

Weight
14,7 kilograms

Capacity
41 Ah

Nominal voltage
52 V

Remote controller

Model
TKPL 2

App
DJI Delivery App

Display
7-inch LCD touchscreen; resolution: 1920 × 1200; brightness: 1.400 cd/m²

Ambient temperature during charging
5 °C to 40 °C (41 °F to 104 °F)

Built-in battery life
3,8 hours

External battery life
3,2 hours

Charging method
Use a USB-C fast charger with a maximum power rating of at least 65 W (maximum voltage of 20 V). A portable DJI charger is recommended.

Charging time
2 hours with built-in battery, 2,5 hours with built-in and external battery (power-off status according to the official charging method)

4G-enhanced transmission
Supported

RTK module for high-precision positioning system
Supported

Operating temperature
-20 °C to 50 °C (-4 °F to 122 °F)

Dual-operator mode
Supported

The second remote controller must be purchased separately.

SDK

PSDK communication interface
Eport-Lite

If you want to connect a third-party payload externally, you must also purchase the DJI FC100 PSDK connection cable combo.

PSDK power interface
Supports 3000 W

If you connect a third-party payload externally, you must also purchase the DJI FC100 PSDK connection cable combo.

C12000 Intelligent Power Supply

Charger model
CSX901-12000

Dimensions
456 mm × 291 mm × 107 mm

Weight
13,13 kg

Input voltage
Three-phase AC input: 175–520 V
Single-phase AC input: 200–264 V

Output voltage
62 V

Rated output current
194 A

Rated power
12.000 W (three-phase 380 V input)
3.000 W (single-phase 220 V input)

Actual output power may vary due to local grid conditions, such as distance, cable material and wire gauge.

Charging time
9 minutes

Charging time from 30% to 95% battery level at sea level at an ambient temperature between 15 °C and 40 °C. Fast charging is supported when the battery cell temperature is between 15 °C and 75 °C. Charging time may vary depending on factors such as input power, ASL and initial charge level.

Protection functions
Overtemperature, overvoltage, undervoltage, short circuit, fan blockage and other protection functions

Operating temperature
0 °C to 40 °C (32 °F to 104 °F)

Output channels
1

D14000iE Multifunctional Inverter Generator

Output channels
1. DC charging output 42–61,6 V/11500 W
2. Air-cooled cooler charging 12 V/6 A
3. AC output 220 V/1500 W

The output power of the charging station is affected by factors such as altitude, fuel quality, etc.

Charging time
9 minutes

Charging time from 30% to 95% battery level at sea level at an ambient temperature between 15 °C and 40 °C. Fast charging is supported when the battery cell temperature is between 15 °C and 75 °C. Charging time may vary depending on factors such as input power, ASL and initial charge level.

Fuel tank capacity
30 l

Starting method
Push-button start

Operating temperature
0 °C to 40 °C (32 °F to 104 °F)

Dimensions
757 mm × 704 mm × 677 mm

Weight
87 ± 0,5 kg

Weight measured at sea level. The weight of the D14000iE All-Round Inverter Charging Station includes 2 kg for the wheels and handle, which can optionally be attached or removed during use.

Fuel type
92 octane petrol or higher

Reference fuel consumption
500 ml/kWh

Engine oil capacity
1,3 l

Engine oil type
DJI-specific S10W-40 engine oil

D-RTK 3 Multifunctional Station (optional)

Dimensions
Diameter: 163 × 89 mm (without OcuSync directional antennas)

Weight
Approx. 1,26 kg

Operating frequency
Relay station mode:
O4: 2,4 GHz/5,2 GHz/5,8 GHz
Base station mode:
O4: 2,4 GHz/5,8 GHz

Relay station range extension
Relay station performance improvement:
Overcomes major obstructions (e.g. buildings, mountains): 3- to 5-fold performance improvement
For minor obstructions (e.g. trees, glass): 1- to 3-fold performance improvement
The relay station must be installed in a high, unobstructed location without interference.

Built-in battery operating time (at room temperature)
D-RTK 3 Multifunctional Station:
Relay station: 4 hours
Base station: 7 hours

Range may decrease at low temperatures. It is recommended to use a power supply that supports the USB PD3.0 protocol for charging.

Ingress protection rating
D-RTK 3 Multifunctional Station: IP67

Make sure that all rubber plug connections on the housing are properly fitted.

Positioning accuracy
Base station mode and relay station mode

Base station positioning error:
Single-point accuracy (uncalibrated):
Horizontal: 1,5 m (RMS)
Vertical: 3,0 m (RMS)

Satellite-based differential accuracy:
Convergence time: 20 min
Horizontal: 30 cm (RMS)
Vertical: 40 cm (RMS)

• 1 drone
• 1 remote controller
• 1 power cable
• 1 DJI USB-C power adapter
• Tools